Panasonic NA-120VG6

38
Water supply hose
 0DLQVZDWHUSUHVVXUHDQGZDWHUÀRZ
zWater pressure: 0.03-1 MPa
If the water pressure exceeds this
YDOXH¿WDSUHVVXUHUHGXFLQJYDOYH
z:DWHUÀRZIURPWDS/PLQRU
more

Connecting the water supply hose
CAUTION
z'R127WZLVWVTXDVKPRGLI\RU
cut the hose.
z7LJKWHQWKHQXW¿UPO\
1 Attach one end of the hose to the
water inlet on the appliance and
tighten by hand.
Water inlet
Water supply
hose
(Rear of appliance)
2 Attach the other end of the hose to
the tap and tighten by hand.
min.
10 mm
3/4"
3 Turn on the tap slowly and make
sure there are no leaks.
Drain hose
 Draining to a sink or wash basin
CAUTION
Secure the drain hose with an elbow
so that it does not come off by water
pressure during drainage.
Elbow
(supplied)
 Draining to a stand pipe
Stand pipe
 Draining to a drain hole
NOTE
zDo not twist, pull out or bend the
drain hose.
zDo not put the hose tip under water.
Connecting the Hoses (continued)
Water supply
hose
NA-120VX6_EN(New Zealand).indd 38 2017-9-29 14:46:29