Panasonic NA-127XB1

1
2
345678
Descriptions of Operating Buttons Preparations before Washing
Preparations before Washing Descriptions of Operating Buttons
14 15
1. Power Button
Press this button to power on the washing
machine. At this time, the indicator lamp
goes on. The washing machine is shut down
if you press this button when the machine is
operating.
3. Program selection knob
Select an appropriate program for the item
to be washed. This enables better washing
effects.
2. Start / Pause Button
Start: press this button to start up the
washing machine after the required
program and functions have been selected.
5. Preset Button
This button allows you to preserve the
end time of the washing. Continuously
pressing it allows you to switch between
3-24 hours. The preserved time indicates
that washing will be finished after 【 xx 】 .
6.Water temp Button
The default washing temperature varies for
different washing programs. This button
allows you to select the water temperature
suitable for the washing.
7.Spin speed Button
The default spinning speed varies for
different washing programs. This button
allows you to select the spinning speed
suitable for the washing.
4. Tub Clean Button
Press 【Power】and 【Tub Clean】, and
then press 【Start/Pause】to execute the
tub clean program. This program is not
enabled if the initially selected button is not
【Tub Clean】, unless you press
button again and select it at first. All functional
buttons are disabled except for 【Power】
button when this program is running. Do not
select selection knob before press
【Tub Clean】.No child lock setting and
unlocking functions are available. Therefore,
you can not pause its operation.
【Power】
8.Options Button
This button allows you to select different
functional programs as needed (see P16
for details).
Spin Speed + Water Temp
To set 【Child Lock】 function, press and
hold the two functional buttons for about 3 s
after the operation started.
【 Child Lock 】 function is intended
to prevent a child from touching the control
panel during washing, which may cause
changes in the program or improper
washing (see P21 for details).
Bedding programme
Make sure that the label of each item to
be washedshows either the wash (
)
hand - wash symbol ( ).
- Wash only one blanket at a time.
Washables:
---100 % synthetic fibre bla nkets
–
up to 3
kg.
--- 100 % synthetic fibre futonsand100%
cotton blankets – up to 1.5 kg (single
size)bed
--- Sheets.
--- Bedspreads.
--- 100 % synthetic fibre undersheets.
Non-washables
--- 100 % wool blankets
--- Long - piled blankets
--- Electr ic blankets (including cover)
Caution
Before closing the door, make sure
that all laundries have been put into the
inner drum as shown in the figure to
prevent the laundries from being caught
by the drum, which may damage the
laundries or the gaskets.
Putting bedding into the drum
1. Fold down blanket or bedspread into a quarter of
their original size.
2. Put the blanket or bedspread into the drum.
Fold it while putting it into the drum (fold into 1/6
of the original size).
Both ends of blanket should face the rear of the drum.
Caution
Do NOT roll the blanket or bedspread
into balls, or haphazardly fold them.
This may cause excessive vibration and
damage the laundry or the appliance.
Do not use the blanket nets. Otherwise,
spinning will fail.
Operating Instructions
Pause: press this button to temporarily
disable the program during operation of the
machine. Re-press this button to continue
executing the program.
or