Panasonic NA-F135A5WSA

Operation Panel
9
NOTE
 In case of a
power failure
during operation,
operation will
resume from the
point where it was
stopped when the
power is recovered
(Auto Restart).
 The power turns off
automatically if you
do not press “Start/
Pause” within
10 minutes after
power-on.
Water level/water amounts
Level
High
10-8
Mid
7-5
Low
4-2
Extra Low
1
Model
Detergent*
Water amount
(L)
93 86 81 73 66 58 52 46 38 33
NA-F135V5
NA-F135A5 / NA-F135A5WSA
86 81 73 66 58 54 52 46 38 33 NA-F115A5 / NA-F115A5WSA
* : 1 scoop of detergent
 Water level for “Soak Program” in accordance with standard SASO 2885
- NA-F135V5 / NA-F135A5WSA : Full load: 93 L / Half load: 73 L
- NA-F115A5WSA : Full load: 86 L / Half load: 73 L
 Each water level, except “Extra Low”, has three water amount options that can be switched
while the level is lighted by pressing “Water Level”.
(Example: For NA-F135V5, “High” has 93 L, 86 L and 81 L options.)
Temp Setting
For washing, cold water can be mixed with hot water.
Press the button to select Hot/Warm/Cold. (P. 14)
Do not use water hotter than 60 ºC.
 The estimated water temperature in the tub during
wash process (when hot water is 50 ºC, and
normal water is 20 ºC):
Hot approx. 40 ºC
Warm approx. 30 ºC
 Lamp indications
Lighted: Hot/Warm/Cold is set.
Flashing: Hot water is being supplied.
 Not available for the following programs: Gentle
Hand Wash, Tub Hygiene, Super Dry 90
 Temp setting for “Soak Program” in accordance
with standard SASO 2885 : - Cotton 60: Hot
- Cotton 40: Warm
e
Program selection (P. 10)
Power Off/On
ECONAVI
(P. 15)
Stain Master (P. 17)
AWW9901D3003_EN.indd 9AWW9901D3003_EN.indd 9 7/2/2563 BE 13:307/2/2563 BE 13:30