Panasonic NA-F80S8

16
Error Display
● The buzzer sounds and “U”/“H” and a number are alternately displayed.
● Cancel Child Lock
(P. 11)
if it is set.
Error display Points to be checked
Water cannot drain.
Check the drain water hose for the following abnormalities:
● Is it crushed?
● Is it clogged with lint?
● Is the hose tip under water?
● Is it partially raised higher than 10 cm above the oor?
(P. 14)
● Is the total length longer than 3 m (including the extension hose)?
(P. 14)
When the above problems are solved, you can resume operation by opening and
closing the lid.
The lid is open.
● Did you try to run the washing machine with the lid open?
→Close the lid.
Spin is not possible.
● Are clothes concentrated on one side of the tub?
→Distribute the clothes evenly and close the lid.
● Is the washing machine installed on an unstable
or inclined surface?
→ You can resume operation by opening and
closing the lid.
Water cannot be supplied.
● Is the water faucet turned on?
● Water outage?
● Is the water supply lter clogged with dirt?
(P. 13)
→You can resume operation by opening and closing the lid.
Water has been forcibly drained.
● Water has been forcibly drained because the lid was open for 10 seconds or more
with Child Lock
(P. 11)
set.
→ Unplug the power cord and plug it in again after 5 seconds.
Inspection is required.
● Turn off the water faucet just to be safe. Then, report the error displayed (2-digit
number after “H”) to a service person. Unplug the power cord.
Specications
NA-F80S8
NA-F80V8
NA-F72V8 NA-F67V8
Rated voltage 230 V
Rated frequency 50 Hz
Rated power consumption 1460 W
Standard water amount 55 L 53 L 52 L
Maximum capacity (Dry cloth) 8.0 k
g
7.2 k
g
6.7 k
g
Product dimensions 525 mm (W) x 604 mm (D) x 1035 mm (H)
525 mm (W) x 604 mm (D)
x 995 mm (H)
Product weight 32 k
g
Pressure of tap water 0.03 - 1 MPa (0.3 - 10 k
g
f/cm
2
)