12
Installation
2. Attach the bottom cover.
Preparation:
Set a cardboard, etc. and lay the washing
machine on it, avoiding product damage and
deformation. (Face the front side down.)
1
I
nsert the bottom cover with its
screw hole set at the bottom.
Screw hole
2
Set 6 holes to the corresponding
projections and x with one screw.
Screw hole
Projection
1
Connect.
Insert all the way.
2
Slide the
hose band
in the arrow
direction.
● Slide all the way
until it stops.
Hose band
NOTE
● Do not put the
hose tip under
water.
● Do not raise the
hose higher than
10 cm above the
oor.
10 cm or
less
● Do not extend the
overall length to
more than 3 m.
3 m or less
1. Check the location.
■
Avoid the following locations for installation.
•
Locations with a possibility of freezing
•
Damp locations or locations where it may be exposed to rain, etc.
(To prevent electric shock or re)
•
Locations exposed to direct sunlight
(To prevent malfunction or deformation)
•
Uneven or unstable locations
(on blocks, timbers, a table with wheels, etc.)
External drain
water hose
Water
supply hose
Water tap adaptor
Water supply
valve screw
Bottom cover
3. Attach the external drain water hose.
To Next Page
Loading...
