Panasonic NA-F80VB7 - Detergent, Bleach, and Softener; Adding Detergent, Bleach, and Softener

6
Detergent
Putting in bleach
● Do not use chlorine bleach for coloured clothes to
prevent loss of colour.
● After using chlorine bleach, wash the tub with the
10
Tub Hygiene program without bleach. (P. 11)
● Do not use bleach for the
2
Delicate program.
Putting in softener
● Softener is automatically released during the nal
rinse process.
● To add softener during operation, press “Pause”
rst.
● Up to about 40 ml can be added. To add more
softener, use the
4
Fragrance program.
● When using
concentrated softener,
dilute it with water
before putting it in.
NOTE
● Softener cannot be used with the
8
Water Save
program.
● Do not use separated or solidied softener.
● If “Pause” is pressed during spin cycle, the softener
will be added too early and its e󰀨ectiveness will
decrease.
● The softener will not be added automatically if not
put in by the time wash process is complete.
Concentrated
softener
Water
Put in detergent, bleach and
softener according to the water
level displayed.
● Follow the instructions on each package.
■
Powder detergent/bleach
■
Softener
■
Liquid detergent/bleach
Putting in detergent
● When powdered detergent is poorly soluble, dissolve
in warm water before putting in.
Water of approx. 30 ºC
(approx. 5 L)
•
Put in the detergent little
by little while stirring to
prevent it from getting
hard or remaining in a
powder state.
● If there are many thick or large clothes (jeans,
sheets, etc.) in the tub, the detergent may remain
undissolved. Dissolve the detergent according to the
above method, or reduce the amount of laundry.
● In case of excessive foaming, reduce the amount of
detergent or change the detergent.
● Turn the tub by
hand if it is di󰀩cult
to put in the softener
inlet. (P. 10)