Installation
13
If the installation, test run and inspection of the washing machine are not carried out following this installation
method, Panasonic will not be liable for any accident or damage caused.
4. Connect the water tap adaptor and water supply hose.
1
Connect the water tap
adaptor to the water
faucet.
1
Turn part A to the left until approx.
4 mm of the thread becomes
visible.
2
Loosen the 4 screws.
3
Connect to the faucet and tighten
the screws.
4
Turn part A to the right and tighten
securely. (To prevent water
2
Connect the water
supply hose to the water
tap adaptor.
Insert the hose into the adaptor while
the adaptor.
3
Connect the water
supply hose to the water
supply valve screw.
1
Hold the elbow and tighten the nut.
2
Chec
Water faucet
Water supply hose
Water tap adaptor
CAUTION
Do not twist, squash, modify
or cut the hose.
Part A
Flange
Thread
Lever
Claw
Screw
Elbow
Water supply
valve screw
Nut
Water supply hose
5. Connect the power plug and grounding wire.
In case of a 2-pin power cord, establish a ground.
6. Check that the washing machine is level.
The bubble should be at
the centre of the mark.
Leveller
Bubble
3
Turn to the right to
tighten.
1
the left to loosen.
2
Turn the adjustable
leg to eliminate
wobble.
To lowerTo raise
7. Perform a trial operation.
To Next Page
Loading...
