Panasonic NA-FS95A1

4
QuickWash
Bedding
Operation Panel
Power Off/OnAir Dry (P. 9)
Start/Pause
Program selection (P. 5)
Child Lock lamp (P. 10)
Change water
amount
During the wash
process, press “Water
Level” to change the
water amount.
● Some water amounts
cannot be selected
depending on the
program.
● Only during the wash
process, press “Water
Level” to check the
water amount.
Water level/water amounts
Level
High
10-8
Mid
7-5
Low
4-2
Extra
Low
1
Detergent *
Water amount (L) 99 88 81 74 66 59 52 46 38 33
* : 1 scoop of detergent
● Each water level, except “Extra Low”, has
three water amount options that can be
switched while the level is lit by pressing
“Water Level”.
Water amount/remaining time
After starting operation, indicates
the water amount according to the
amount of laundry.
After approx. 5 seconds, indicates the
approximate remaining time (min).
ECONAVI lamp (P. 8)
NOTE
● In case of a power failure during operation, operation will resume from the point where it was stopped when the
power is recovered (Auto Restart).
● The power turns off automatically if you do not press “Start/Pause” within 10 minutes after power-on.
■
Touch operation
● Operation buttons are capacitive (Except for the power Off/On and Start/Pause buttons). Touch the buttons
directly with your bare fi ngers.
● When a towel containing water or detergent touches an operation button, the appliance may malfunction.
Change process
settings
Change the combination
of wash, rinse and spin
processes, and the time
length or number of times
for individual processes.
(P. 9)
Flashing (in progress)
Lighted
● After starting operation,
you can change settings
only during wash
process by pressing
“Start/Pause”.
Preset
Set the time to fi nish washing
(in hours). (
lights.)
e.g.) 8 hours later
● Setting range: 2 - 24
hours later, in one-hour
increments. (3 - 24 hours
later for the Soak program)
● Not available for the
following programs:
Delicate , Fragrance,
Bedding, Tub Hygiene,
Air Dry
Temp Setting
For washing, cold water can be mixed
with hot water. Press the button to select
Hot/Warm/Cold. (P. 7)
Do not use water hotter than 60 ºC.
● The estimated water temperature in
the tub during wash process (when
hot water is 50 ºC, and normal water
is 20 ºC):
Hot approx. 40 ºC
Warm approx. 30 ºC
● Lamp indications
Lighted: Hot/Warm/Cold is set.
Flashing: Hot water is being supplied.
OM_NA-FS95A1.indd 4OM_NA-FS95A1.indd 4 10/20/2560 BE 10:47 AM10/20/2560 BE 10:47 AM