Panasonic NC-HU401P

— 10 —
NC-HU301P, NC-HU401P
noitcAdohtem citsongaiDkcehC
Thermal fuse Comp. Is there connection between the white lead wire on the peg
frame and the CN3 connector of the control unit A? (0Ω)
Replace the Thermal fuse
comp.
Keep warm heater Is there connection between yellow lead wire on heater
terminal and blue and orange led wires? (Approx.133Ω)
Replace the Container comp.
Power cord Is there connection in the power cord? (0Ω) Replace the Power cord.
Lead wire assy. E Is there connection in the lead wire assy. E? (0Ω) Replace the Lead wire assy. E.
A tinu lortnoC eht ecalpeR.lamron era strap evoba eht n
ehW
comp. (operation)
B tinu lortnoC eht ecalpeR.lamron era strap evoba eht nehW
comp. (bottom)
noitcAdohtem citsongaiDkcehC
Boiling heater Is there connection between yellow lead wire and blue •
orange lead wire? (11Ω)
Replace the Container comp.
A t
inu lortnoC eht ecalpeR.lamron era strap evoba eht nehW
comp. (operation)
B tinu lortnoC eht ecalpeR.lamron era strap
evoba eht nehW
comp. (bottom)
noitcAdohtem citsongaiDkcehC
Is the filter (located at the bottom of the container) clogged? Clean up or replace the filter.
noitcAdohtem citsongaiDkcehC
eht sserp dna retaw ylppuS?e
disni retaw ereht sI
Long Boil/Reboil pad.
noitcAdohtem citsongaiDkcehC
Themistor assy. comp. Is there connection between blue lead wire and blue lead
wire? (Approx. 45Ω when approx. 20°C)
Replace the Thermistor assy.
comp.
B tinu lortnoC eht ecalpeR.lamron era strap e
voba eht nehW
comp. (bottom)
A tinu lortnoC eht ecalpeR.lamron era strap evoba eht nehW
comp. (operation)
3.5. Failure Diagnostics Chart
3.5.1. No power (No indication, no pouring)
The items in the Check correspond to those shown in Check Point on P.9.
3.5.2. Water is not boiled. (Water pours out)
The items in the Check correspond to those shown in Check Point on P.9.
3.5.3 Hot water cannot poured out or water flow is obstructed. (Water is boiled)
Check point
The items in the Check correspond to those shown in Check Point on P.9.
3.5.4. Long Boil/Reboil LED and 98 keep warm LED are lighted up alternately.
(Overheating protection mode/Bottom thermistor disconnection mode)
Check point
The items in the Check correspond to those shown in Check Point on P.9.
noitcAdohtem citsongaiDkcehC
Electric pump Turn the 100V power on, and pres the Lock/Unlock pad  rst
and then the Pour Out pad. Is the motor heard running?
Replace the electric pump.
Lead wire assy. E comp. Is there connection in the Lead wire assy. E? (0Ω) Replace the Lead wire assy. E.
A tinu lortnoC eht ecalpeR.lamron era strap evoba eht nehW
(operation).
B t
inu lortnoC eht ecalpeR.lamron era strap evoba eht nehW
(bottom).