Panasonic NI-C55SR

HOW TO FILL WITH WATER
Make sure the iron is turned off and the AC Power Cord is unplugged from the electrical outlet.
The iron can be filled with the Detachable Water Tank in place or removed. Confirm that the Steam
/Dry Selector is set at the Dry ironing position ( LEFT ) when installing or removing the Tank.
1. When the iron is sitting up
on the Heel Rest, press
the Tank Lock/Release
Button down and the Tank
will be released.
2. Grasp the Tank and lift
it off the iron.
NOTE: Do not pull on or
damage the rubber gasket
that joins the main part of
the iron with the Water
Tank.
3. Open the Water Fill Open-
ing and fill the Tank up to
the" MAX " Line on the
Tank. To check the level
of water, grasp the Tank
vertically.
4. To re-install the Tank, set
the Tank onto the main
body and press into place
until a click sound is
heard.
. The water level can be
observed through the
transparent part of the
Tank, when iron is placed
vertically. When the water
level becomes low, refill
the Tank, following the
procedure described in
steps 1 to 4 above.
Most tap water can be used in this iron. If water is very hard, distilled or demineralized
water should be used. Do not use water processed through home water softening
systems because this water contains minerals that may be harmful to the iron. Do not use
water additives or substitute water such as linen or scented water in the steam iron. They
can stain fabrics or damage the iron.
HOW TO USE AS A STEAM IRON
1. Fill the iron as described in "HOW TO FILL WITH WATER".
2. Position the iron vertically and be sure the Temperature Selector Dial is set to " OFF ".
3. Plug the AC Cord into the electrical outlet.
4. Set the Temperature Selector Dial to the" <>" or nc "(steam) zone.
-6-