Panasonic NI-C55SR

"c^>" zone: Low Steam, for thin or delicate fabrics requiring a small amount of steam.
eS "zone: High Steam, for fabrics requiring a lot of steam (i. e. thick materials, items
with stubborn wrinkles).
5. Preheat the iron until the Indicator Light goes out, usually about 1-2 minutes.
This Light will go on and off during ironing to indicate the temperature chosen by the
Temperature Selector Dial is being maintained.
6. Hold the iron horizontally and move the Steam/Dry Selector into the steam position.
Steam/Dry Selector is regulated as follows.
NOTE: 3 Positions Steam/Dry Selector .
Dry Low Steam High Steam
(Right : for High Steam, Center: for Low Steam )
Temperature Zone | Steam/Dry Selector Position
7. Whenever the iron is positioned vertically, the steaming action will stop.
A
CAUTION
Do not use the Steam/Dry Selector at low or high steam positions until the Thermostat
Operating Indicator Light turns off after setting the Temperature Setting Dial within the
steam range. Otherwise hot water may leak from the Soleplate and burns may result.
HOW TO USE JET-OF-STEAM"FEATURE
The"Jet-of-Steam'feature provides extra steam which goes deep into the garment and
is helpful for removing stubborn wrinkles. The"Jet-of-Steam" feature operates properly
only inthe" & " indication area of the Temperature Selector Dial when steam or dry
ironing( If used at lower setting, water spotting will occur because the iron is not hot
enough to change water to steam ). If you have not used the " Jet-of-Steam " feature
for a long time, it is necessary to clean the inside of the iron before using this feature
on any clothes to be ironed. Simply test the "Jet-of-Steam" feature several times
away from the ironing board and clothes to be ironed. This will prevent brown spotting
or water spotting on the clothes.