Panasonic NI-C55SR

1. Fill the iron as described in "HOW TO FILL WITH WATER".
2. Position the iron vertically and be sure the Temperature
Selector Dial is set to " OFF ".
Plug the AC Power Cord into the electrical outlet.
3. Set the Temperature Selector Dial to the " & " indication area. 4
4. Preheat the iron until the Indicator Light goes out, usually
about 1-2 minutes.
5. Simply pump the " Jet-of-Steam Button " when steam is
desired. Pump the " Jet-of-Steam Button " several times CY
at the beginning of each ironing session. OJ
6. Allow at least 2-5 seconds between uses of "Jet-of-Steam Ar
Button " to prevent water spotting. Use a press cloth if
necessary.
A
CAUTION
Do not use "Jet-of-Steam Button " until the Thermostat Operating Indicator Light turns
off after setting the Temperature Selector Dial to" 6 ".
Otherwise hot water may leak from the Soleplate and burns may result.
HOW TO USE "VERTICAL STEAM" FEATURE
To get better results when using vertical steam, hang
the garmenton a clothes hanger. Curtains and drapes
may also be steamed once they're hung. Hold the iron
away from your body, close to but not touching the fabric.
Pull the fabric tight with your free hand and pump the
Vertical Steam Button(Jet-of-Steam Button) at 2-5 seconds
intervals as you pass the iron over the wrinkled fabric.
A
WARNING
Never iron clothes on the body or point your iron at anyone when steaming.
Keep hands and body away from steam areas while using vertical steam feature.
HOW TO USE THE SPRAY FEATURE
Before using the spray feature, check the fabric label for ironing instructions because some
fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed.
The spray may be used with steam or dry ironing.
int 8 =