Panasonic NI-C55SR

1. Simply pump the Spray Mist Button A when spray is desired.
If the spray doesn't work immediately, keep pumping
until it does.
2. To get a finer spray, pump the Button vigorously.
To get a more powerful spray, pump the Button more
slowly. For best results, use a quick, full stroke.
HOW TO USE AS A DRY IRON
1. Move the Steam/Dry Selector to the Dry position.
2. Position the iron vertically, set the Temperature Selector Dial to " OFF ".
3. Plug in the iron.
4. Set the Temperature Selector Dial to the desired position,
(Refer to the Fabric Ironing Chart in this manual on page 12 )
5. Preheat the iron until the Indicator Light goes out, usually about 1-2 minutes.
SELF-CLEANING
With the self-cleaning feature you can flush out mineral residue from the steam generating
chamber and the steam vents, refreshing your iron each time for a longer steaming life.
It is very important to operate the self-cleaning feature after each steam ironing to prevent
mineral accumulations from hardening.
1. Check water level. Water level should be at 1/2 full mark.
When water level is less than half full, fill with water according
to the instructions in" HOW TO FILL WITH WATER".
2. Preheat at "6" setting (in about 1-2 minutes).
Make sure that the Steam/Dry Selector is in the Dry position.
3. Set the Dial to "OFF" and remove the AC Plug.
4. Hold the iron horizontally over the sink.
5. Pump the "Jet-of-Steam Button " quickly (at least 3
times per second) about 20-30 times.
6. While self-cleaning, tilt the iron up and down slowly to
help clean the entire inside and let the water drip out of
the soleplate vents.
7. Check that all water and steam have completely stopped
coming out of the soleplate vents. After self-cleaning is finished
empty any remaining water from the Water Tank, by turning
the iron upside down to empty the Water Tank from water inlet.
8. Iron on a towel to remove any drops of water remaining on the bottom of iron.