Panasonic NN-CS88LBEPG

EN
Select F1 (Drain
Water) by tapping
.
Select F2 (System
Cleaning) by tapping
.
Tap Auto
Cook pad
once.
Tap Auto
Cook pad
once.
F1. Drain Water
Water is pumped through the system to clean the pipes. The water is drained
into the drip tray.
F2. System Cleaning
7KHÀUVWVWDJHRIWKLVSURJUDPFOHDQVWKHV\VWHPZLWKDFLWULFDFLGVROXWLRQ
The second stage runs water through the system to rinse the pipes.
Touch Start/
&RQÀUPDWLRQ
Empty the drip
tray after the
program has
ÀQLVKHG
Make a solution of
20
g
citric acid and
250 ml of water, add
the solution to the
water tank. Ensure
drip tray is empty.
After the program has
SDXVHGÀOOWKHZDWHUWDQN
with water (to max level).
Touch Start/
&RQÀUPDWLRQ
The program
will run for
29 minutes.
7RXFK6WDUW&RQÀUPDWLRQ
The program will run for approx.
1 minute. Empty the drip tray after the
SURJUDPKDVÀQLVKHG
Cleaning Programs
Note
1. Only run this program with 100 g of water in the tank.
2. Do not remove the drip tray during the drain water program.
3. Empty the drip tray and rinse with running water after the program has
ÀQLVKHG
Caution
If the Drain Water program is used directly after a steam cooking program,
hot water may be drained into the drip tray.
Add 100 ml of
water
to the water
tank. Ensure drip
tray is empty.