English
- Eng-31 -
Before Requesting Service (continued)
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in securely.
Remove plug from outlet, wait 10 seconds
and re-insert.
Circuit Breaker or fuse is tripped or
blown.
Contact the specified service center.
There is a problem with the outlet.
Plug another appliance into the outlet to
check if the outlet is working.
Oven will not start cooking.
The door is not closed completely. Close the oven door securely.
Start/Set pad was not pressed after
programming.
Press Start/Set pad.
Another program has already been
entered into the oven.
Press Stop/Reset pad to cancel the
previous program and program again.
The program has not been entered
correctly.
Program again according to the Operating
Instructions.
Stop/Reset pad has been pressed
accidentally.
Program oven again.
"
" appears in the display
window.
The cavity is overheated. Operate again after it cools down.
"U14" appears in the display
window.
The water tank is empty. Full it with water.
"H97" or "H98" appears in
the display window.
This display indicates a problem with
the microwave generation system.
Contact the authorised service center.
"
" appears in the display
window.
The oven is under demonstration
mode.
Press Micro Power pad once, Start/Set
pad 4 times and Stop/Reset pad 4 times.
The " " appears in the
Display Window.
The Child Lock was activated by
pressing Start/Set pad 3 times.
Deactivate Lock by pressing Stop/Reset
pad 3 times.
If it seems there is a problem with the oven, contact an authorized Service Center.
To Next Page
Loading...
