7 EN
English
The oven lamp must be replaced by a service technician
trained by the manufacturer. Do not attempt to remove
the outer casing from the oven.
Before using the oven, place the drip tray in position.
Refer to page 15 for correct installation.
The purpose of the drip tray is to collect excess water
during steam and microwave mode. It should be
emptied after each steam and microwave operation.
Do not use the water tank if it is cracked or broken, as
leaking water could result in electrical failure and danger
of electric shock. If the water tank becomes damaged,
please contact your dealer.
Caution! In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must not
be supplied through an external switching device, such as
a timer, or connected to a circuit that is regularly switched
on and o by the utility.
Safety instructions
To Next Page
Loading...
Need help?
General