7.5. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 1 screw holding diode (U) on side of the oven.
3. Disconnent 2 H.V. lead wires which linking to H.V. transformer
from H.V. capacitor terminals.
4. Remove 3 screws holding orifice assy and detach the orifice assy
from oven assy.
5. Remove fan blade from the motor shaft by pulling it straight out.
6. Remove 2 screws holding fan motor on orifice assy and detach
the fan motor from orifice assy.
7.6. Door assembly
1. Remove door C from door E by carefully pulling outward starting
from upper right hand corner using a flat blade screwdriver.
2. Separate door E from tabs on door A and remove door A.
3. Remove door screen B from door A.
4. Remove handle spring which hitching door handle, seperate door
handle from door A by pulling outward door handle slightly,
moving it towards the side of door A and out.
18
To Next Page
Loading...
