7.3. Troubleshooting of inverter circuit (U) and magnetron NEW H.V.
This oven is programmed with a self diagnostics failure code system which will help for troubleshooting. H95, H97, H98, and H99
are the provided failure codes to indicate magnetron and inverter circuit problem areas. This section explains failure codes of H95,
H97, H98, and H99. First, you must program the DPC by pressing Reheat
pad once, and then pressing 10 min. pad thrice.
Program unit for operation. H95, H97, H98, H99 appears in display window a short time after start key is pressed and there is no
microwave oscillation.
Alternate way to troubleshoot oven with AC Ampere meter used
H95, H97, H98, H99 appears in display window a short time after start key is pressed and no microwave oscillation with AC Ampere
meter used for troubleshooting
19
NN-GD376S / NN-GD366M / NN-GD356W
To Next Page
Loading...
