from the terminal pins of the low voltage transformer and/or power relays.
NOTE:
Do not use a soldering iron or desoldering tool of more than 30
watts on DPC contacts.
(B) With all the terminal pins cleaned and separated from DPC contacts, remove the defective
transformer/power relays making sure all terminal pins are inserted completely. Resolder all
terminal contacts carefully.
5.4. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 1 screw located on oven attaching orifice assembly.
3. Remove orifice from oven assembly.
4. Remove 2 screws holding fan motor to oven assembly.
5. Remove fan blade from the fan motor shaft by pulling it straight
out.
5.5. Door assembly
1. Remove door C from door E by carefully pulling outward starting
15
To Next Page
Loading...
