5.6. Turntable motor
1. Remove the motor cover by cutting at the locations indicated by
the arrows with a cutter.
NOTE:
After removing the motor cover, be sure that cut portions are
properly trimmed or bent to the inside so that no sharp edges will
be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After replacing the new turntable motor and reconnecting the two
lead wires, reinstall the motor cover by rotating it 180°, tucking
the tabs into the base in the 2 provided slots, then screw the
single tab to the base using a 4mm X 6mm screw (not provided). /
17
To Next Page
Loading...
