Some recipes call for a standing
time after cooking. To do this,
repeat steps 1 and 2 in the
Cooking
section on previous
page. Then press
Timer
.
Note: Do not skipstep 1, evenuse
high power P .
L10
2
. The timer will start
Press
Start
; the cooking will
start and the time will count
down in the display. At the
end of cooking, five beeps will
sound.
NOTES:
1.
For reheating, use PL10
for liquids, PL7 (MED-HIGH)
most foods, and PL6
for dense foods.
2.
For defrosting, use PL3
(MED-LOW).
DO NOT OVERCOOK
: This
oven requires less time to cook
than older units. Overcooking
will cause food to dry out and
may cause a fire. A microwave
oven’s cooking power tells
you the amount of microwave
power available for cooking.
Stage Cooking:
For more than one stage of
cooking, repeat steps 1 and
2 for each stage of cooking
before pressing
Start
. The
maximum number of stages
for cooking is three. When
operating, two beeps will
sound between each stage.
Five beeps will sound at the
end of the entire sequence.
Note: After running the oven
at PL10 power continuously
for 30 min, if the cook
process is not complete, the
oven will automatically adjust
to PL8 power to protect the
microwave and complete the
cook cycle.
If you want to cook again at
PL10 power, you will need to
wait 15 min before restarting.
dial. PL10 (HIGH)
minutes. For
seconds.