56
3. Remove the ice maker a’ssy.
a. Turn the ice maker a’ssy to a side so that your
hand can reach the back of it.
b. Remove the first screw from your left to detach
the wire.
c. Cut the cable tie on the Bag Joint to take out all
connectors from Bag Joint and disconnect them.
You can now remove the ice maker a’ssy.
NOTES ON INSTALLATION
• After connecting back all the connectors, put all con-
nectors back into the BAG JOINT and tighten it with
cable tie as before.
11.5.2. HOLDER CONTROL DISPENSER
AS., PAS-DIS PANEL (BUTTON)
1. Remove Holder Control Dispenser AS.
a. Remove 2 screws and pull the ice dispenser a’ssy
down to detach it from the FC door a’ssy (but you
cannot remove it now).
2. Remove PAS-DIS PANEL (BUTTON)
a. Disconnect the connector that connect the
HOLDER CONTROL DISPENSER AS. to the DOOR
AS. FC. Now you can remove the HOLDER
CONTROL DISPENSER AS. from DOOR AS. FC.
b. Disconnect PAS-DIS PANEL (BUTTON) connector
from ice dispenser a’ssy.
c. Push the PCB (Ice Dispenser) Cover to detach it
from the Ice Dispenser A’ssy. Then release 6
hooks at the PCB (Ice Dispenser) Cover to remove
the PCB (Ice Dispenser).
NOTES
• Be careful not to break PAS-DIS PANEL (BUTTON) when
removing and installing.
To Next Page
Loading...
