ALL THESE THINGS ARE NORMAL:
Sounds will occur when
using the Steam function.
This is caused by air mixed when the water tank is working. It is
normal.
The sound of “Bar... Bar...”
may be emitted at the back
of the oven cavity during
and after the use of different
kinds of Convection function.
This is a cause of thermal expansion and contraction of the metal
material used in the product. It is normal.
Steam accumulates on
the oven door and warm
air comes from the air
outlet.
During cooking, steam and warm air are given off from the food.
Most of the steam and warm air are removed from the air outlet by
the air which circulates in the oven cavity. However, some steam will
condense on cooler surfaces such as inside or on the oven door.
It is normal.
Steam leaks out from all
four sides of the oven
door.
When a function related to steam is used, a lot of steam are
generated in the oven cavity during operation of the product. Some
steam may leak from all four sides of the oven door. It is normal.
I accidentally operated
my oven without any food
in it.
Operating the oven empty for a short time will not damage the oven,
however, it is not recommended.
The oven has an odour
and generates smoke
when using Convection
and Steam Convection
function.
It is essential that your oven is wiped out regularly, particularly after
cooking by Convection and Steam Convection. Any fat and grease
that builds up on the roof and walls of the oven will begin to smoke
if not cleaned.
The fan motor continues
operating after cooking is
over.
After using the oven, the fan motor will operate for several minutes
to cool the oven and electric components. It is normal.
The rear side of the oven’s
color has yellowing.
Metal ions will generate yellow marks when heated. It is normal that
will not affect the use of the oven and harm to human health.
Door seal maybe
deformed.
The door seal may be distorted due to high temperature. It is
normal and will not affect the performance of use of the oven.
Some smoke and odour
will be given off from the
cavity when using different
kinds of Convection
functions for the first time.
It is caused by the excessive oil in the cavity used for rust
protection.
The part where the power
supply cord connects to
the product’s bottom plate
has loosened.
It is normal.
To Next Page
Loading...
