Others
-60-
ª Memory Stop Function
The Memory Stop Function is useful for the
following operations.
Rewinding or fast-forwarding a tape to a
desired position
1 Set [DISPLAY] >> [C.DISPLAY] >>
[MEMORY].
2 Reset the Tape Counter to zero at the tape
position from which you want to play it
back later. (
-8-, -16-)
3 Start playback or recording.
4 After playback or recording has finished:
Set the Movie Camera to Tape Playback
Mode.
5 Rewind the tape.
≥The tape automatically stops approximately
at the position where the counter was set to
zero.
Stopping editing automatically during audio
dubbing
1 Set [DISPLAY] >> [C.DISPLAY] >>
[MEMORY].
2 Reset the Tape Counter to zero at the
position where you want to stop editing.
3 Play back the still picture where you want to
start audio dubbing.
4 Start audio dubbing. (-41-)
≥Audio dubbing automatically stops at the
position where the counter was set to zero.
15B-ENG.book 60 ページ ２００４年２月２日 月曜日 午後４時４５分
To Next Page