Panasonic OLED-201806 - Page 75

GK board
<Disassemble> <Assemble>
From design concept, the rear cover structure for some model is changed. The screws are decreased and
there are hooks on the rear cover.
Rear Cover Disassemble / Assemble -3
Target model : TX/TH/TC-49/43FX6##, TH-49/43FX5## ( other inch is same as previous model)
1.Remove all screws for rear cover.
2. Pull the bottom of rear
cover towards yourself.
*The left side is hard a little because
of hook next of the control button.
3. Lift the rear cover up and remove it.
*It is hard a little. Refer to right
structure drawing
1.Fit the top side of rear cover.
2. Push the circumference of
rear cover and right side of
control button and fit it.
Check that there is no
floating all circumference
and fix all the screws.
<Side View>
Panel
Rear Cover
Push also next to control button
Panel
Rear Cover
Control button
<Side View from Top>
(bottom)
(top)
75