Panasonic Omnivision PV-9451 - Timer Recording; Initiating Timer Program Setup; Setting Recording Date and Details; DSS Receiver Recording Notes

imer
ecording
You can set up to 8 programs to be recorded while you are away.
1 Display SET PROGRAM.
Press PROG.*
You can also display Program screen from Menu.
1) Press ACTION to display Menu.
* You can also set up using VCR buttons. See the bottom right of this page.
2) Press AY and > to select and set SET UP FEATURE.
3) Press » to display Program screen.
4) Go to step 3.
Display Program screen.
1) Press AY to select
TIMER PROGRAM.
2) Press P to display.
* If a program is already in
memory, press AV and
> to select an unused
program number.
VCR Plus+ PROGRAM
TIMER PROGRAM
SELECT:4 ¥ KEY
SET :> KEY
END : PROG KEY
« You may not use the VCR buttons
on “SET PROGRAM” screen.
TER START STOP CH
OBAY\
CATEGORY : N/A SLP
SELECT:4 ¥ KEY
SET :b» KEY
END :PROG/ACTION KEY
Set the recording DATE.
3
2) Press > or 4 to set.
* 1~31 = One time
e DAILY = MON-FRI
e WEEKLY = Same time
once a week
Example
7890-31
1
2
6
Today—7
SELECTA/
Y
Selection
Order
L wecky _ WEEKLY __ WEEKLY
(SAT) (MON) (SUN)
Repeat step 3 to set:
patty Start time, stop time
Channe! (or LINE for
tape speed (SP, LP, SLP).
Make the notes.
e if not wanted, go to step 5.
1) Press A to begin.
2) Press AV to select.
3) Press P to set.
+ Characters will change in
the following order.
Ar Be Ca---> Zer BLANK. — «> 8
E E Se
4) Press PROG (or
ACTION) to end.
DATE___START___STOP___ CH
8 SAT 10:00P 12-008 125
TODAY BC
CATEGORY : MOVIE
WISH TO MAKE NOTES :4 KEY
SET :4 > KEY
END :PROG/ACTION KEY
4
DATE START___STOP___ CH
8 SAT 10:00P 12:00P 125
AB
SELECT:A Y KEY
SET :> KEY
END ¿PROG/ACTION KEY Continued on the next page.
Important notes when using a DSS receiver
» When recording programs via a DSS receiver, the DSS
receiver must be left on.
+ When recording programs via an antenna or cable, the DSS
receiver must be turned off.
12
1) Press AV to select.
outside source), Category”,
[A creck list before you begin.
O Alt connections are made.
(See pages 4~5.)
O TV and VCR are plugged in and turned on.
[O VCR/TV selector is set to “VCR.”
[O Clock is set to correct time.
[] Record tab in place. (See page 34.)
L] Remote in VCR mode.
6 POWER
SELECT/
Model PV-9451 remote is shown here.
** Category Items
N/A(not applicable), SPORTS,
MOVIE, COMEDY, MUSIC, DRAMA
Using AV<4 > keys
You can also operate the menu screen
using VCR buttons.
lf you use VCR buttons, press CH Aand
CH F together to display the menu screen.
onver | >:FF
When menu screens are displayed,
PLAY, STOP, REWIND, and FF buttons
function as AV« > only.
For assistance, call 1-800-211-PANA(7262).