Panasonic Omnivision PV-9451 - Copying Your Tapes (Dubbing); Dubbing Connection Setup; Dubbing Process Instructions; Input Mode Selection for Dubbing

opying Your lapes (Dubbing)
Connections you'll need to make. (Choose front or rear connection.)
For Model PV-9401
IN FROM ANT.
AUDIO VIDEO
OUT
Niol o
OUT TO TV
Playing (Source) VCR
For Model PV-9451
IN FROM ANT.
R-AUDIOL VIDEO ©
OUT
N1
O Ol ourttotv
Insert pre-recorded
tape.
AUDIO VIDEO ™ “o ANT. Ey AUDIO IN
000 O UHF O
E VIDEO IN
OUT TO TV ©
or
VIDEO IN 2 AUDIO IN 2
FrontofvcR| O O TV for Monitoring
Recording (Editing) VCR
IN FROM ANT.
R-AUDIO-L VIDEO © VHF/ AUDIO IN
OUTDO
O
O
UHF
O
1 y MONO æ VIDEO IN
OUT TO TV O
or
Front of VCR O O O
Playing (Source) VCR Recording (Editing) VCR
Insert blank tape
=> with record tab.
O Select LINE mode.
oon Press INPUT. (See “Selecting
C the Input Mode” below.)
3
Put
in
Standby
mode.
CD
and
Press
PLAY,
then
PAUSE
at
starting
point.
PAUSE Start dubbing.
Press PAUSE.
= Stop dubbing.
D Press STOP.
m To Monitor Dubbing on Your TV
1 Turn your TV on and tune to the Recording
VCR channel (CH3 or CHA).
2 Set the VCR/ TV Selector on the Recording
VCR to “VCR.”
f Note J Dubbing tapes protected with Copy Guard
will have poor quality results.
REG PAUSE
shi
PAUSE
Stop dubbing.
Press STOP.
E Selecting the Input Mode
Method 1: Press INPUT.
Channel Number <--> LINE1 <--> LINE2
Put in Standby mode.
Press REC, then
PAUSE immediately.
Start dubbing.
Press PAUSE.
Method 2: Press CH A/V. Display will change as below.
142243
( CABLE) (TV) )
LINE2e LINE Tee 25 or 69
s “L1” or “L2” lights on Multi-Function Display (about 4
sec.) when LINE1 or LINE2 is selected.
¢ LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
Caution: Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.
23
O
je]
ke
S,
=)
(a
<
O
c
=
+
0)
po
M
Y
O
=
T
J
3
g