Panasonic Omnivision PV-9451 - Weak Signal Display Feature Settings; Auto Shut-Off Function Control

: O
` TAPE POSITION, or ADD/DLT button does not work when Dead “press the VCR button on the
remote and try the button again.
Weak Signal Display ON/OFF Feature
When “ON” is selected, picture is displayed even when broadcast
signal is weak or nonexistent.
1 Display menu.
Press ACTION.
Display SET UP CHANNEL.
SET UP VCR
SET UP FEATURE 2 1) Press AY to
select.
2) Press > to
display.
Set
ON
or
OFF
2
serecrr
MA
1) Press AV to ~ SET E
select. A:PLAY o
2)
Press
P
to
set.
V:STOP
MJ
SELECT: Y KEY ea <
SET :» KEY O
* ON --> Picture is displayed regardless of signal condition, and J
may not always be clearly visible. 1 ACTION mT
OFF -->Screen turns solid blue when signal is absent or weak. » ri)
e If VCR is connected to equipment which has blue back feature, 4 Q
selecting ON will have no etfect on the other equipment. ha E
C 0
0
Return to normal
4 screen.
Press ACTION twice.
Auto Shut-Off Feature
When “ON” is selected, VCR shuts itself off when playback of a blank
portion of tape continues or no signal (except when LINE is selected)
is detected for over 5 minutes.
Repeat step “a” and “b” on page 30 to
display SET UP VCR.
Model PV-9451 remote is shown here.
SET UP VCR Set ON or OFF.
1) Press AY to
select.
2) Press P to set.
REPEAT PLAY
AUTO SHUT-OFF
SELECT:A Y KEY
SET :> KEY
END ‘ACTION KEY
Return to normal
screen.
Press ACTION twice.
31