Panasonic Omnivision PV-9451 - Multi-Brand Control Feature; Remote Control Setup for External Devices; Operating External Devices with Remote

WuIti-Brana Control Feature
The Remote Contro! may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
POWER
Setup
for
TV
Setup
remote.
D
Wor
Hold down TV and enter code DSS/ CABLE
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys.
* For code 100 or greater, press the
100 key first, then remaining digit.
E.g. for 102, press 100, then press 0, D NUMBERED
and
then
press
2.
keys
Confirm code entry.
Press POWER to turn
selected unit ON or OFF.
* See table below for list of
controllable functions in each mode.
Cp e Please repeat Multi-Brand Control setup after replacing
remote control batteries.
* The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
.
7
Model
PV-9451
remote
is
shown
here.
Using
the
Multi-Brand
Control
After remote contro! is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Buttons VCR TV
All Functions VOL UP/DOWN
TV
VORITV,
PLAY,
STOP
|
POWER,
INPUT,
JECT, SAP/ Hi-Fi (PV-
NUMBERED keys,
eet only), DISPLAY, TER CH UPIDOWR
FF, REW, PAUSE, SLOW,
REC, SPEED, ZERO/ VOL UP/DOWN
1MIN, COUNTER RESET
CABLE/ DSS
CABLE/ DSS VCR/TV, PLAY, STOP
EJECT, SAP/ Hi-Fi (PV-
9451 edt DISPLAY FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER RESET
VOL UP/ DOWN POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/ DOWN
c>
in
TV
or
DSS/
CABLE
mode,
it
may
be
necessary
to
press
ENTER
after
pressing
NUMBERED
keys
for
channel
selection,
18 For assistance, call 1-800-211-PANA(7262).