Panasonic Omnivision PV-V4601 - Page 11

‘Important: If a remote contro! button does not work when pressed, press
the VCR button on the remote and try the button again.
box or DSS receiver. Press A Y to select
5 Confirm the output channel of your cable
the same channel as the cable box or
P emm
DSS receiver output channel. Press » to E
enter.
Q
=
52
POWER 0
CaSMNEL CLR AUTO Set - (D
VCR oc
VCRTV ES
SELECT/
SET
‘ A ¡PLAY
Turn on your cable box and set it to v:STOP
your Public Broadcasting Station »-FF
(PBS) channel in your time zone.
If you use a DSS receiver, it must be ACTION
turned off.
CHA/vV
Press CH A Key to start Channel/Clock
6 Auto Set operation. The Channel/Clock
Setting is performed automatically.
If the setup is completed, the following
screen appears.
T
5/19/2001 SUN” 2:20PM
ON DST:
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
END :CH UP KEY
If “Auto Clock Set is Incomplete"
Screen appears, set the clock using
MANUAL CLOCK SET procedures
shown on page 9.
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
11