Panasonic Omnivision PV-V4601 - MTS Broadcast; VHS Hi-Fi Stereo System a

MTS Broadcast/ VHS Hi-Fi Stereo System
Connection
Make the Audio/Video Connection as shown
on the previous page.
* You can use a TV connected to Stereo amp
and speakers instead of a Stereo TV.
Receivable Broadcast Types
The following are possible audio broadcast types and on-screen displays.
The signal being received is indicated with an “(«" mark while the selected
audio mods is indicated with an arrow.
To display the broadcast signal being received,
STOP 12:00AM ABC
-> press DISPLAY. 0:00:00
#STEREO « SP
b SAP
MTS Ster n P a t
Multi-channel Tetevision Sound Stereo (main
language) and Secondary Audio Program (sub
MONO
language) broadcasts are being received STOP 12:00AM ABC
j j 0:00:00
simultaneously. Select STEREO or SAP audio berenin’s =
mode, , SAP
MONO
MTS St roa :
Multi-channel Television Sound Stereo
broadcast. Select STEREO audio mode. STOP 12:00AM ABC ,
y à 0:00:00
* |f stereo broadcast is weak and display STEREO SP
flickers, select MONO audio mode for ESAP s - : e ]
possibly better results. Equipped with dbx”-TV Noise
Reduction for true MTS
AP br t reproduction. dbx*-TV Noise
Secondary Audio Program (sub STOP 12:00AM ABC Reduction is required for good
language) broadcast. Select SAP audio 0:00:60 stereo separation and audio
mode for the sub language. STEREO SE fidelity. dbs is a registered
MONO broadcast MONO a«a trademark, and is licensed by
e . :
Normal monaural sound broadcast. dbx* Technology Licensing.
Audio Mode for Recording Audio Mode for Playback
OP
Press
SAP/
Hi-Fi
1
Start
playback.
pe
2
to display audio mode. See page 14. D 5
(Display disappears after 5 seconds.) PERRERA Y
2 Press SAP/ Hi-Fi = a
to display audio mode. -—
Press
SAP/
Hi-Fi
: :
O
o
2 PPTERED | repeatedly to select (Display disappears after 5 seconds.) 50
desired mode. Press SAP/ Hi-Fi
repeatedly to select
‘i ] desired mode.
» Arrow indicates + Refer to “Receivable
selection. Broadcast Types” above. HIF) (L/R) 4 » Select "HIFI(L/R)" or
“HIFI(L)” or *HIFHR)" to
listen to stereo
recordings in stereo
sound. Select "NORMAL"
* Arrow indicates for monaural sound.
[Notes | selection.
* Only tapes recorded in Hi-Fi stereo will playback with true stereo sound. Standard stereo tapes will
playback in monaural sound.
* To listen to Hi-Fi stereo playback, the VCR AUDIO (L/R) jacks must be connected to a stereo TV or an
external stereo amp and speakers. (See top of this page.)
* If tracking is adjusted during playback, Hi-Fi audio may revert to normal audio.
* Hi-Fi and normal audio playback volume level may differ. 2 5
Do a recording.
See page 15.