Panasonic Omnivision PV-V4601 - VCR & Cassette Information

VCR & Cassette Information
Head Cleaning Specifications
Playing older or damaged tapes may Power Source: 120 V AC, 60 Hz
clogged. Approx. 23 watts
Video Head Clog Sensor Vi e ovis
isi A Video Signal: EIA Standard NTSC color
clogging is detected. VIDEO HEADS uv Video Recording System:4 rotary heads helical
To remove screen, PLEASE INSERT HEAD scanning system
Audio Track: 1 track (Normal)
press PLAY on the
2 channel (Hi-Fi Audio Sound)
remote or VCR.
Tuner:
Broadcast Channels: VHF2-13,UHF 14-69
CABLE Channels: Midband A through | (14-22)
1 Superband J through W (23-36)
K d. 5D ] Hyperband AA~EEE (37-64)
LowbandA-5-A-1 (95-99)
3
Special
CABLE
channel
5
A
(01)
*
Use
“dry”
type
head
cleaning
cassette
`
Ultraband65-94,
100~125
only.
Operating
Temperature:
5
°C~40
°C
(41
°F~104
°F)
(Part No.
a
à
recommandas}
Operating
Humidity:
10%-75%
* Follow cleaning tape instructions carefully. Weight: 2.7 kg (6.0 Ibs).
Bo ere USE OT TAPO- CaN enorten: nes Dianalona: 430 (W) x 98 (H) x 242 (D) mm
i . 16-15/16" (W) x 3-7/8" (H) x
* |f head clog symptoms persist, contact ` 9-9/16"(D)
your nearest Factory Service Center or
authorized Service Center. (See page 36.) Note: Designs and specifications are
EF subject to change without notice.
Built-in Head Cleaner :
A clean video head helps produce a clear Features fora Quality Picture
picture. Digital Auto Picture
So, we have equipped your VCR with a built- Automatically controls the video output signal for
in, non-chemical head cleaning System that — less noise depending on the tape condition.
helps prevent clogging of the video heads.
Cleaning is performed each time you load or Digital Auto Trackin i
unload a video cassette. Continuously analyzes the signa! and adjusts for
* This feature is preventative only, If your opium picture quality
video heads are seriously clogged, Manual Trackin ntrol (to r ictu
consider the use of a chemical non- noise) l
abrasive head cleaning kit or take your Use during Playback and Slow Motion mode to
VCR to a Service Center. reduce picture noise. Press CH (TRACKING)
: A / Y buttons on the remote control or on the
Cleaning the VCR VCR until the picture clears up. To return to Auto
Use a soft cloth or dusting attachment of a Tracking, press POWER off, then on again a few
vacuum cleaner to remove dust from the seconds later.
ventilation holes on the back sides and
bottom of the cabinet.
Plastic surfaces are easily scratched and
can be marred by alcoho! and various
solvents. Avoid excessive use of oil-based
furniture polishes since the materials used in
the cabinet will accumulate more dust. We V-Lock Control (t u ure Jitt
recommend using a nonabrasive, antistatic IN Still mode, CH (TRACKING) A / Y buttons
cleaner and polisher. operate as a V-Lock control. 33
IIT 104
=]
m
O
=
-
i
=p
Q
-