Panasonic Omnivision PV-V4601 - Initial Setup for ANT.; Cable-VCR-TV Connection

Initial Setup for ANT./ Cable -VCR -TV Connection
How to Connect
Connect the Cable from Antenna/Cable to the IN FROM ANT.
terminal on VCR. |
Connect the OUT TO TV terminal onthe rear of VCR to the ANT.
IN terminal on TV using the RF Cable (included accessory).
VCR IN FROM ANT.
i O IN from
a ANT/CABLE
OUT TO TV ..
VHF/UHF
How to do Initial Setup
Press VCR button* on the Press CHA to select English.
1 remote for VCR mode. Turn the or
TV on and set it to channe! 3. Press CHYF to select Spanish.
or
Turn
VCR
on.
Press
VCR/TV
key
to
select
French.
When
VCR
is
turned
on
the
first
When
one
of
above
keys
is
pressed,
time, SELECT LANGUAGE screen SELECT CONNECTION screen is
appears.
displayed
in
the
selected
language.
S CH A : ENGLISH
: ESPANOL
CABLE/DSS BOXPVCRETV
VCRPCABLE/DSS BOXPTV
SELECT:a * — SET:*
EXIT — :ACTION -
If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4. i and press M to set.
When you want to change the output CHANNEL/CLOCK AUTO SET
channe! of VCR, please refer to VCR's screen appears.
d Channel on page E 3.
If wrong language is set, do "Reset All QUITTTERTETUETETNTS
VCR Memon Functions” steps on Gini CLOCK AUTO SE
page 9. CONNECT ANTENNA CABLE
A Press A ¥ to select connection
WARNING
When using “Nut type” RF coaxial cables, tighten with fingers
only. Overtightening may damage terminals.
PLEASE PRE UP K
For assistance. please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@ panasonic.com