Panasonic Omnivision PV-V4601 - Page 13

VCR's Output Channel
*Important: |f a remote control button does not POWER
work when pressed, press the VCR VCR
button on the remote and try the SELECT/
button again. SET
A :PLAY
v:STOP
«:REW
b:FF
li
Time
Zone
Adjust
M
VCR's
Output
NUMBER
(Only when Auto Clock is set.) Channel keys
1) Press « > to select 1) Press AY to select ACTION
CLOCK. VCR'S OUTPUT CH. ADD/DLT
| Se UR
TIME ZONE ADJUST : ET SHUT- OFF E : CHA/Y
Ei AY 4»
O
U
©
=
to
=.
O
5
2) Press AY to select | 2) Press b.
TIME ZONE ADJUST
CLOCK ] CHANNEL |
IF YOU PRESS ACTION
KEY, VCR'S OUTPUT CH
TIME ZONE ADJUST SWITCHES TO CH 4.
Add or Delete a Channel
To add channel:
Select channel with number
keys and press ADD/DLT.
| CHANNEL 08 ADDED |
and press < or b to 3) Press ACTION. To delete channel:
subtract or add hour(s
number keys and press ADD/DLT.
PLEASE TUNE YOUR TV TO
CH 4.
| CHANNEL 08 DELETED |
SELECT:A Y SET:4 >
EXIT ¿ACTION .
3) Press ACTION.
4) Press POWER off and
wait a maximum 10
minutes until AUTO After 3 seconds
CLOCK SET is
performed by the VCR.
DST (Daylight Saving Time)
VCR auto adjusts clock for DST.
(Page 9.)
Spring (First Sunday in April)
DST:ON --> Sets clock ahead one hour.
Autumn (Last Sunday in October)
DST:ON --> Turns clock back one
hour.
* If your area does not observe
Daylight Saving Time, select
DST:OFF.
Keep these time changes in mind
when programming the VCR for
timer recordings. *
+ TIME ZONE ADJUST
returns to “0” if clock is
set manually.
* To Make Corrections,
repeat step 1) - 3).
13