Panasonic Omnivision PV-V4601 - Page 17

"Important: lí a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1) Press :
PROG/VCRebuton. | Recording in progress
2) Press <> S ea
to select LIST. Press POWER and then STOP
within 10 seconds to cancel the
Timer Recording. (The TIMER
indicator goes out on Multi
Press AV Function Display.)
to select number.
9:00P10:00P Lt LP
CANCEL :ADD/DLT
LECT :A Y
: PR
SE SET: >
EXIT
3 To Replace program...
SELECT STARTOATE — ^ (pg.16) to set
SELECT: v SET:4»> . hewprograms. SELECT/
|
1)
Press»
`
©
DATE”
—
START
STOP
H
f
E|
to
display.
8
-:
l|
2)
Repeat
Step
3
z
3
(Q
END
or
To Clear program...
[VCR Plus» | PROG. | Li Press ADD/DLT.
P DT START STOP CH SPD
ETRE
2 8 10:00P 12:00P 02
3 10 8:00P 9:00P 10
4 SU 9:00P 10:00P L1
ADD/DLT
CANCEL :ADD/OLT
SELECT :A Y SET
X :PHCK
Press PROG/VCR+ button
to end the program.
* tf there are set programs, press
POWER off to set timer.
Important notes when using a DSS receiver
* When recording programs via a DSS receiver, the DSS
receiver must be left on.
* When recording programs via an antenna or cable, the DSS
receiver must be turned off.
17