Panasonic Omnivision PV-V4601 - Page 19

"Important: If a remote contro! bution does not work when pressed, press
the VCR button on the remote and try the bution again.
Auto VCR Plus+ System Channel Setup (Part 2)
Before you perform the following steps, you
should have:
* completed “Auto VCR Plus+ System Channel
Setup (Part 1)” on page 18.
* left VCR off overnight, and turned it back on after
SELECT/
. SET
9:00 AMthe next day. A :PLAY
Y :STOP
It channel updating was If | «:REW
1
successful...
istinguish
>
:FF
ACTION
ADD/DLT
Press ACTION Press ACTION
to exit this mode. to display SELECT VCR
Plus+ CH. y
Continue with step 2. O
O
Press AV 4b to select o
channel map for your area Q.
and 5
press ADD/DLT to set. To Change or Update Auto VCR ©
Plus+ System Channel Setup
(E.g. you selected wrong channel
map or zip code.)
Press ACTION a Do “Auto VCR Plus+ System
PLEASE LEAVE VER OFE to end. Channel Setup (Part 1)” steps
OVERNIGHT 1~4 on page 18.
* Make sure to leave
VCR off (overnight.) ATE VEA PE. DH
SI VCR Plus+ C
Channel map will be updated (overnight.) b Press AW toselect UPDATE VCR
If it was successful, “VCR Plus+ CH SET Plus+ or SELECT VCR Plus+ CH
COMPLETED” appears on screen. And then, thenpressP. t
press ACTION to exit.
c Ifyouselected UPDATE VCR Plus+
CH, perform steps 5-7 in the "Auto
VCR Plus+ System Channel Setup
(Part 1)" section on page 18.
If
Auto
Setup
fails,
do
"Manual
VCR
Plus+
System
ifyou
selected
SELECT
VCR
Plus+
Channel Setup” on page 20. CH. perform steps 2-3 in the “Auto
VCR Pius+ System Channel Setup
(Part 2)” section on this page.
Repeat these steps as necessary.
19