Panasonic Omnivision PV-V4601 - Page 21

“Important: If a remote control button does nat wark when pressed, press
ihe VCR button on the remote and try the button again.
VCR Plus+ System Programming
[A Ready Check List
O Clock is set.
O vcr Plus+ Setup is complete (see pages 18-20).
1 (VCR Plus+ [»PROG. | LIST]
: DATE START STOP C
TODAY
to display PROGRAM.
SELECT: a4 Y 4 >
¿PROG
EXIT
Press 4»
ENTER PLUSCODE NUMBER ||. to select display VCR
- Plus+ screen.
USING 0-9 KEYS
SELECT: a yar
Press number keys
ENTER PLUSCODE NUMBER || to enter PlusCode
i number and press .
PROG/VCR+ button to set.
To Make Corrections,
press « repeatedly
to delete number, then
repeat step 3.
elf the PlusCode number entered begins with “0,”
skip to step 5. Display in step 4 will not appear.
USING 0-9 KEYS
BACKSPACE : «
NG ¿PAGA
Press AV
to select ONCE, -
DAILY(MON-FRI), or
WEEKLY record frequency
and press PROG/VCR+
button to set.
4
Press AV
to change record speed
and press > to set.
13 SAT 220P 3
TODAY
—SLP
SELECT RECORD SPEED / 5
SELECT: a Y SET: 4 >
¿PROG
END to end program.
Press PROG/VCR« button
again to exit.
* Press ADD/DLT
to delete the program.
CANCEL :ADD/DLT
SELECT :A Y
EXIT : PROG
Press POWER off to set timer.
(TIMER” lights on Multi Function Display.) .
Press PROG/VCR+ button
Press PROG/VCR« button |
POWER
SELECT/
SET
A :PLAY
v :STOP
«:REW
b:FF
PROG/
VCR+.
NUMBER
keys
ACTION
ADD/DLT
Do normal Timer Record if...
* PlusCode number is not listed for
program.
* program (e.g. sports event) may run
over set stop time. : f
See page 17 to: ©
* cancel a timer recording in progress.
* review, replace, or clear program
contents.
Important for OSS/Cable Box Users
* When recording via DSS, the receiver
must be left on. When recording via
cable or antenna, DSS receiver must
be off.
* When recording via a cable box,
leave box on and tuned to channel to
be recorded.
* Do not overlap:program times.
* PlusCode numbers cannot be used to
program VCR to record DSS and
cable box channels. : .
* Make each entry within 1 minute or the
VCR will exit setup mode.
* Once VCR Pius+ channel setup is
done, channels stay in memory. If a
power interruption occurs, VCR Plus+
channel setup may be lost. Please do:
VCR Plus+ channel setup again.
* Obtain unlisted PlusCode numbers by
calling 1 - 900 - 454 - 7587. Call costs
about $.95 per minute.
JJ
(D
O
o
~
=
=
tO