Panasonic Omnivision PV-V4601 - Page 28

Tape Operation (Continued)
Repeat Play
Set to playback a recording over and over.
Press ACTION’
to display menu.
Press AV
to select REPEAT
PLAY and
press P>
to set ON or OFF.
2
SELECT/SET
* Play repeats at tape end or if unrecorded
portion over 30 sec. is detected. A :PLAY
¡STOP
Press ACTION Lr
to return to normal screen. :
ACTION
Zero Search
| ZeroSearch pen
To quickly return to a specified tape location. RESET
Press DISPLAY during play
to display Counter.
DISPLAY
Press COUNTER
RESET at desired
CM/ZERO
position
to reset to "0:00:00".
3 Continue to record, playback etc.
4 Press STOP.
Press CM/ZERO
In Stop mode
to start ZERO
SEARCH.
* Unit will go into FF or REW mode and
stop at the last point the Counter was
set to 0:00:00.
qu * If a blank portion exists on the tape, and depending on the position
of the V mark, the V mark display position may not be accurate.
For assistance. please call : 1-800-211-PANA(7262) or send e-mail to : consumerproductsG panasonic.com