56
1 Display the thumbnail display screen.
2 Press [MENU/MODE CHK].
3 Using , and , select “PROPERTY”
– “DEVICES” – “SD CARD”, and press .
The following information is displayed.
SD STANDARD: Whether the SD card has
been formatted in compliance
with the SD/SDHC standard is
displayed.
SUPPORTED: The card format
complies with the SD/SDHC
standard.
NOT SUPPORTED: The card
format does not comply with the
SD/SDHC standard.
USED: Used memory [bytes]
BLANK: Free memory [bytes]
TOTAL: Total memory [bytes]
NUMBER OF
CLIPS:
Number of clips contained on
the SD card when the clips
were copied onto the SD card
with a proxy or P2 camera-
recorder
PROTECT: Write-protect status
Proxy recording is not possible with this unit.
4 Press .
5 Press [MENU/MODE CHK] to exit the
procedure.
•
Displaying SD card information
You can display the usage statuses of SD cards on the screen, and check them.
Clip management (continued)
To Next Page
Loading...
