Panasonic P50GT30 - Remove the K-Board; Remove the S-Board; Remove the V-Board

27
9.15. Remove the Stand bracket
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Unlock the cable clampers to free cable.
3. Remove the Stand bracket fastening screws (×10 , ×4
, ×4 ) and the Stand bracket.
9.16. Remove the K-Board
1. Remove the SP shield metal L. (See section 9.14.)
2. Remove the Stand bracket. (See section 9.15.)
3. Remove the screw (×1 ).
4. Remove the claws (×3 ).
5. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
9.17. Remove the S-Board
1. Remove the SP shield metal L. (See section 9.14.)
2. Remove the screws (×2 ).
3. Disconnect the connector (S10) and remove the S-Board.
9.18. Remove the V-Board
1. Remove the SP shield metal R. (See section 9.14.)
2. Remove the Stand bracket. (See section 9.15.)
3. Remove the screw (×1 ) and remove the claws (×3
).
4. Disconnect the connector (V14) and remove the V-Board
from the 3D LED panel.
9.19. Remove the Bottom cabinet
assy
1. Remove the Speakers. (See section 9.14.)
2. Remove the Stand bracket. (See section 9.15.)
3. Remove the K, S and V-Board. (See section 9.16 - 18.)
4. Remove the screws (×2 ) and remove the Bottom cab-
inet assy.