Panasonic P50GT30 - Remove Plasma Panel Section from Cabinet; Remove the C1-Board; Remove the C2-Board

28
9.20. Remove the Plasma panel sec-
tion from the Cabinet assy.
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
2. Remove the Bottom cabinet assy. (See section 9.19.)
3. Remove the screws (×8 , ×14 ).
4. Remove the Plasma panel section from the Cabinet assy.
9.21. Remove the Contact metals
1. Remove the Cabinet assy. (See section 9.20.)
2. Remove the Tape from the Contact metals.
3. Remove the screws (×6 ).
4. Remove the Contact metal side (L, R).
5. Remove the screws (×6 ).
6. Remove the Contact metal top.
7. Remove the screws (×15 ).
8. Remove the Contact metal bottom.
9.22. Remove the C1-Board
1. Remove the Contact metal bottom. (See section 9.21.)
2. Disconnect the flexible cables (CB1, CB2 and CB3).
3. Disconnect the flexible cable (C10).
4. Disconnect the connector (C14).
5. Remove the screws (×3 ) and remove the C1-Board.
9.23. Remove the C2-Board
1. Remove the Contact metal bottom. (See section 9.21.)
2. Disconnect the flexible cables (CB4, CB5, CB6, CB7,
CB8 and CB9).
3. Disconnect the flexible cables (C20, C21 and C26).
4. Remove the screws (×4 ) and remove the C2-Board.