Special Features
The PV-DC252 and PV-DC252-K models come with card
functions.
Using a Memory Card
A Card can be used to record files or play back files.
≥Use a genuine SD Memory Card or MultiMediaCard only.
ª Inserting a Memory Card
Before inserting a Memory Card, be sure to turn off the Palmcorder.
1
Open the Card Slot Cover.
2
While holding the Memory Card with its cut corner
A
facing
right, insert it into the Card Slot.
3
Close the Card Slot Cover securely.
Removing the Card
Open the Card Slot Cover, press the centre of the Card and then pull it
straight out.
≥After removing the Card, close the Card Slot Cover.
≥The Palmcorder or the Card may be damaged if the Card is forced out when
the Card is fully inserted.
ª [ACCESS] Lamp
While the Palmcorder is accessing the Card (reading, recording, playback,
erasing, moving of images), the [ACCESS] Lamp
1
lights up.
≥While the [ACCESS] Lamp is on, never attempt: to pull out the Card, to turn
off the Palmcorder power, or to switch the [TAPE/CARD] Selector. Such
actions will damage the Card and cause the Palmcorder to malfunction.
~~~~~~~~~~~~~~~~~~~~~~~~
Recording on the Memory Card
≥If the [TAPE/CARD] Selector is set to [CARD], the Palmcorder is
automatically turned off when you leave it for about 5 minutes without
performing any PhotoShot recording.
≥When the [TAPE/CARD] Selector is set to [CARD], you cannot record to the
Tape.
ª Card PhotoShot
Recording from the Palmcorder Lens (CAMERA Mode)
1
Set the [TAPE/CARD] Selector to [CARD].
≥The [PICTURE] Indication
1
appears.
2
Press the [PHOTO SHOT] Button.
≥The [ ] Indication will light in red.
≥The power is automatically turned off after about 5 minutes when a cassette
has been inserted.
≥With the Progressive PhotoShot Function, you can record still pictures with
higher resolution than with the normal PhotoShot Function (l 21).
PICTURE
To Next Page
Loading...
