Panasonic Palmcorder Multicam PV-DC152 - Quick Guide; Initial Setup and Operation

7
1
2
3
4
5, 6
OPEN/
OPEN/
EJECT
EJECT
CLOSE
PUSH
1
2
O
F
F
O
N
M
O
D
E
4
CAMERA
VCR
CARD
P.B.
3
CAMERA
VCR
CARD
P.B.
5
9
8
SEARCH
BACKLIGHT
FADE
MAGICPIX
MULTI/
P-IN-P
TITLE
CAMERA
STILL
SEARCH
67
O
F
F
O
N
M
O
D
E
Quick Guide
1
Charge the Battery.
(l 12)
≥Connect the AC Cable to the AC Adaptor and plug it into the AC Wall
Outlet.
≥Attach the Battery to the AC Adaptor. (This will start the charging
process.)
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
2
Attach the Charged Battery to the Palmcorder.
(l 12)
3
Insert the Cassette.
(l 13)
≥Slide the [OPEN/EJECT]
1
Lever toward the front and pull down to
open the Cassette Compartment.
≥Insert the Cassette.
≥Press the [PUSH CLOSE]
2
to load the Cassette.
≥Close the outside compartment Cover.
4
Start recording.
(l 20)
≥Turn the Palmcorder on. (l 14)
≥Rotate the Switch
3
to [ON]. (The [CAMERA] Lamp lights up.)
≥Press the
4
Button. (Recording starts.)
≥Press the
4
Button again to pause the recording.
To View the Playback Picture
5
Switch to the VCR Mode, rewind the tape, and play the tape
back.
(l 29)
≥Set the
5
Switch to VCR mode. (The [VCR] Lamp lights up.)
≥Press the
6
Button. (Rewind the tape.)
≥Press the
7
Button. (Playback starts.)
≥Press the
8
Button. (Playback stops.)
6
Turn the Palmcorder off.
(l 14
)
≥Set the
9
Switch to [OFF].