Panasonic Palmcorder Multicam PV-DV73 - Transferring Your Images (I.link) (Windows)

71
PC Connection
Transferring Your Images (i.LINK) (Windows)
DV Interface Cable (i.LINK)
(6-to-4 pin) (not supplied)
PC Connector
DV Input/Output
(i.LINK)
Connector
PC Connection with DV Interface Cable (i.LINK)
Our DVC being OHCI compliant should have no problem working
with any OHCI compliant Firewire Card/video - Editing software
package.
A video clip can be transferred directly to your PC (Personal Computer) via a DV Interface
Cable (i.LINK) (not supplied) using products and software from a number of video editing
software companies.
Using products from video editing software companies allows you to capture and edit
video clips using the DV Interface (i.LINK).
• PC must be equipped with an i.LINK terminal.
• During Palmcorder playback, do not disconnect the DV Interface Cable (i.LINK) or turn
the Palmcorder off as this may cause a PC hang-up error.
• For PHOTOVU/MPEG4 Movie Messenger™ System, do not use 2 i.LINK terminals on
your PC at the same time.
• PHOTOVU/MPEG4 Movie Messenger™ System i.LINK (DV) operates normally with
Windows 98SE or later operating system.
• PHOTOVU/MPEG4 Movie Messenger™ System i.LINK connection may not work with
some DV Interface boards. In this case, use the software included with the board.
• 1394 (i.LINK) Interface must conform to OHCI (Open Host Controller Interface
Specification).
Note
DV73.p 71-73.p65 2003/06/30, 17:0271