Panasonic Palmcorder PalmSight PV-L757 - Page 22

Camera Recording
Stand-by Quick Release
Whenever the Palmcorder is left in RECORD/PAUSE mode for 5 minutes, it will automati-
cally switch to Stand-by mode to conserve energy. Activating the Stand-by Quick
Release feature altows you to release the Stand-by mode and resume recording by
simply pressing the RECORD/PAUSE button. if this feature is not activated, it is neces-
sary to turn the Palmcorder OFF and back on to CAMERA to start recording again. The
default setting from the factory is set to the eiii mode.
Before you begin...
* Connect the Palmcorder to a power source.
* insert a cassette with record tab (see page 10).
1 Continue holding down the UP A
button before and after turning the
POWER switch to CAMERA until the
STAND-BY RELEASE menu screen is
displayed.
2 Press UP A or DOWN Y to select
ACTIVERTINON-ACTIVER
STAND-BY RELEASE
BY RECORWPAUSE KEY
ACTIVE
DISPLAY
NON-ACTIVE
You can resume recording from Stand-
by mode by pressing the RECORD/
PAUSE button.
RECORD/PAUsE AMANS
You must set the POWER switch to
OFF, and then to CAMERA to release
the Stand-by mode.
3 Press DISPLAY to set your selection
and exit this screen.
22