Panasonic Palmcorder PalmSight PV-L757 - Play Back your Recordings; Playback Using the EVF

Play Back your Recordings
Playback using the EVF
Before you begin...
» Connect the Palmcorder to a power source,
* Insert a recorded cassette.
1 Set the POWER switch to VCR.
2 (& Press the REWIND/SEARCH
Special Effects Playback
To rapidiy locate a scene
Press FAST FORWARD/SEARCH or
REWIND/SEARCH for rapid visual search.
Press again, or press PLAY to resume
normal speed.
View a Still Picture
Press STILL to freeze the picture.
Press again to resume normal playback.
Note:
* During search playback, horizontal noise bars
will appear and there will be no audio.
* To protect the tape and the video heads, your
Palmcorder's operating modes will revert as
follows:
STILL ———+* STAND-BY after 5 minutes.
STANDBY — POWER OFF after 5 minutes
when using a Battery Pack.
+ When the tape reaches its end during playback,
or fast forward, it will rewind automatically.
24
button to rewind the tape.
(B Press PLAY to start playback.
© Press STOP to stop playback.
Auto Play
When the POWER switch is set to VCR,
playback will automatically begin if the
record tab has been removed on the
cassette.
Search Speed
Standard Play (SP) Search is about 3 times the
normal speed, and Super Long Play (SLP)
Search is about 9 times the normal speed.
Tracking Control
Auto Tracking
Continuously analyzes the signal of each
recording for optimum picture quality.
Manual Tracking
To minimize the noise in some recordings,
manual tracking may be necessary.
For Noise in Playback mode:
Press UP A or DOWN Y until picture
clears.
Press DISPLAY to return to Auto Tracking.
For Noise in Still mode:
Press UP A or DOWN Y until picture
clears.
V-Lock Control (Reduces jitter in Still
mode.)
Press DISPLAY and UP A or DOWN Y
until picture is stable.