48
Manual Number Dialing
To dial the telephone number manually, follow the steps below. (see Note 1)
(see Note 2)
1
Set document(s) face down.
2
Make sure that the MEMORY lamp is on.
If not, press to set “On”.
3
Enter a telephone number from the keypad.
Ex:
4
The document is stored into memory with a file number.
Then starts to dial the telephone number.
1. If you need a special access number to get an outside line, dial it first then press to enter a pause
(represented by a "-") before dialing the full number.
Ex
: 9 PAUSE 5551234
2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing, press
(represented by a "/").
The dilaing mode will be changed from Pulse to Tone after dilaing the digit "/".
Ex: 9 PAUSE TONE 5551234
To Next Page
Loading...
