-28-
Removing the wireless card
#
##
# Close Wireless Manager if it is running.
$
$$
$ Left-click on the PC Card icon (
) on the taskbar at the
bottom-right corner of the screen.
Note:
• If the PC Card icon does not appear in the taskbar at the bottom-right of
the screen, click “Start”, point to “Settings”, click “Control Panel” and then
open “PC Card”. Click the “Show control on taskbar” check box and then
click “OK”.
%
%%
% Select “Stop Panasonic Wireless
Card”.
&
&&
& The screen shown at right will
appear. Click “OK” to remove the
wireless card.
Installing the driver
When the wireless card is inserted, the driver installation screen appears.
The driver can be found on the CD-ROM which is included with the
projector as an accessory.
Install the driver by following the procedure below.
For Windows 98
Note:
• The Windows 98 Setup CD-ROM may be needed while the driver is
being installed.
#
##
# When the wireless card is inserted,
the “Add New Hardware Wizard” will
start. Click “Next”.
To Next Page
Loading...
