Panasonic PT-LB332

ENGLISH - 93
Power/Warning Indicators
When an indicator lights up
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering Off the
Projector” (x page 37).
Power indica-
tor <ON(G)/
STANDBY(R)>
Warning
indicator
<WARNING>
Status Cause Solution
Off Off The power cord is unplugged. -- --
Red
Lighting Off
The power cord is plugged. -- --
The projector is in standby
mode after the cooling is
completed.
-- --
Lighting Lighting in red
The replacement time of
the lamp unit is displayed.
(Standby mode)
f The indicator lights up
when the usage time of
the lamp unit reaches
6 000 hours (when [Lamp
control] is set to
[
(Eco 1)]).
f Replace the lamp unit.
Lighting Blinking in red
It has exceed the replace-
ment time of the lamp unit
and the projector is turned off
automatically.
f The indicator blinks when
the usage time of the
lamp unit reaches
6 600 hours (when [Lamp
control] is set to
[
(Eco 1)]).
Blinking Off
The projector inside is
cooling down and after a
while, the projector is turned
off. (The projector will enter
into the standby mode)
-- --
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Chapter 6 Maintenance - Power/Warning Indicators