Using WebBrowser (cont.)
Projector control window
You can make various projector settings.
If you migrate from other page, click [Projector control] in the main menu (at the left of the window).
Basic control window
On this window, click the [Basic control] tab.
Advanced control window
On this window, click the [Advanced control] tab.
Connection with the projector may not be possible immediately after the power is turned on. In this case wait a bit and then
make the connection again.
Detailed set up window
Network config
You can make detailed wired LAN settings.
1
Click [Detailed set up] → [Network config] in the
menu.
Confirm the notes that appear on the screen and
2
click [Next].
The settings window appears, showing the current settings.
To change the LAN settings, click [Change].
•
To return to the previous window, click [Back].
•
To Next Page
Loading...
